Import-Export Bulletin Board  

Home > Offers to Sell > Home Appliances > Home Appliances Parts & Accessories

Contact: Amy Liu
Company: Huahui New Energy CO.,LTD
NO.3 Liji Lane,2nd Industrial Area Xiaobian Chang'an Town
Dongguan 523850
China
Phone: 0769-81601908
Fax: 0769-81601678
E-Mail: Send Inquiry
Date/Time:  12/9/16 13:35 GMT
 

FC8710 Clean Robot 4IFR19/66 12.8V 2600mAh Secondary Super Li-ion battery

Please kindly be noted: The battery is made by original factory HUNAN HUAHUI
NEW ENERGY CO.,LTD

Before your purchase, please message us to check if the transport is available
to your country.

More inquiry, please email to address: amyliu_01 (at) 163.com

1.Note For Use Of Battery

Please use and charge the battery in Philips specified model only.

For this specification, the battery pack consists of 4 single-cell,1300mAh
battery series connection,voltage is 12.8V and the total capacity is 2600mAh.

Battery Standard charge: Constant Current 1300mA(0.5C), end Voltage 14.6V, 26mA
cut-off, Approx 2.5h.
Battery Standard discharge: Constant current 2600mA(0.5C),end voltage 9.2V,
Battery Fast charge: Constant Current 2600mA(1.0C),end Voltage 14.6V,26mA cut-
off,Approx 1.5h
Operation Temperature Range: Charge at 0~40℃,Discharge at
-10~70℃(60±25%R.H.Bare Cell)
Storage Temperature Range: Less than 1 year: -10~20℃,Less than 1 year:
-10~20℃( 60±25%R.H.at the shipment state)

2.Handling of Cells

Cell fixing
The cell should be fixed to the battery pack by its large surface area.No cell
movement in the battery pack should be allowed.

Inside design
No sharp edge components should be insides the pack containing the LIP cell.

3.Other notice

Prohibition of disassembly
1)Never disassemble the cells.The disassembling may generate internal short
circuit in the cell, which may cause gassing, firing, explosion, or other
problems
2)Electrolyte is harmful.Battery should not have liquid from electrolyte
flowing, but in case the electrolyte come into contact with the
skin, or eyes, physicians shall flush the electrolyte immediately with fresh
water and medical advice is to be sought.
Prohibition of dumping of cells into fire

Prohibition of dumping of cells into fire
Never incinerate nor dispose the cells in fire. These may cause explosion of
the cells, which is very dangerous and is prohibited.
Battery cells replacement.

4.Battery cells replacement
The battery replacement shall be done only by either cells supplier or device
supplier and never be done by the
user.

Please do not exceed the specification range using the battery

5.Storing the Batteries
The batteries should be stored at room temperature, charged to about 30% to 50%
of capacity. We recommend that batteries be chargedabout once per half a year
to prevent over discharge.

6.Test assurance
Vibration Test
After standard charging, fixed the cell to vibration table and subjected to
vibration cycling that the frequency is to be varied at the rate of 1Hz per
minute
between 10Hz an 55Hz, the excursion of the vibration is 1.6mm. The cell shall
be vibrated for 30 minutes per axis of XYZ.
Test result,No leakage,No fire.

Crush(Fresh,Fully charged)
Crush between two flat plates. Applied force is about 13kN(1.72Mpa) for 30min.
Test result,No explosion, No fire.

Short Circuit(Fresh,Fully charged)
Each test sample battery, in turn, is to be short circuited by connecting the
(+) and (-) terminals of the battery with a Cu wire having a maximum resistance
load of 0.05Ω.Tests ae to be conducted at room temperature(20±2℃ ).
Test result,No explosion,No fire hetemperature of the surface of the Cells are
lower than 150℃.

Impact(Fresh,Fully charged)
Discharge at a current of 1 C5A for 2.5h.
Test result,No explosion,No fire.

Minimum Order: 1 sets

SOURCE: Import-Export Bulletin Board (http://www.imexbb.com/)
Report Abuse

Involved in International Trade? Become an Advertiser!

Post an Offer to Sell

© 1996-2010 IMEXBB.com. All rights reserved.

IMEXBB.com