Home > Offers to Sell > Electronics & Electrical > Wires & Cables > Power Cables
||Henan Tinde Power Co.,Ltd.
||15th Floor,Block D,Building 18,No.283 Xisanhuan Road, High-Tech District, Zhengzhou City, Henan.
||11/29/16 4:58 GMT
Medium Voltage Fill Shield Power Cable
Conductor: Solid or Class B compressed concentric lay stranded 1350 aluminum
meeting the requirements of ANSI/ICEA S-97-682.
Conductor Shield: Extruded semi-conducting thermosetting polymeric stress
Insulation: Extruded Ethylene Propylene Rubber (EPR) Class II and III as
defined in ANSI/ICEA S-97-682.
Insulation Shield: Extruded semi-conducting thermosetting layer, clean and free
stripping from insulation.
Copper Wire Shield: Helically applied annealed solid bare copper wires with a
lapped non-metallic tape serving as a binder/separator.
Jacket: Black, non-conducting, sunlight-resistant (PVC) or LLDPE.
Triple-extruded for clean interfaces
Flexibility for easy handling
Excellent moisture resistance
High dielectric strength
Low dielectric loss
Excellent resistance to water treeing
Clean-stripping insulation shield without the use of a release agent
Standard: ANSI/ ICEA S-97-682 and AEIC CS8
Medium Voltage Fill Shield Power Cables are intended for use in dry or wet
locations for distribution of three-phase medium-voltage power. Because it's
filled with shield, these medium voltage cables may be installed in ducts or
Minimum Order: 100 metres
Click to Enlarge
SOURCE: Import-Export Bulletin Board (http://www.imexbb.com/)
Involved in International Trade? Become an Advertiser!
Post an Offer to Sell
© 1996-2010 IMEXBB.com. All rights reserved.