Import-Export Bulletin Board Guangzhou Zhenroumei Chemical Coatings Limited Logo

Home > Offers to Sell > Chemicals & Plastics > Paint, Pigments & Dyestuff > Paint

Contact: Qiqin Huang
Company: Guangzhou Zhenroumei Chemical Coatings Limited
No. 16, industrial Avenue Shihai
Conghua 266600
China
Phone: 86-020-87833698
Fax: 86-020-87833698
E-Mail: Send Inquiry
Date/Time:  12/7/18 7:46 GMT
 

MF-680 Extra Fast Clear Coat.

MF-680 Extra Fast Clear Coat.
Automotive Paint company
Product Name/Model:MF-680 Extra Fast Clear Coat.

Characteristic:Extra fast drying clear coate, high gloss and hardness, easy
application, low consumption and high efficiency to ensure good profit, suitable
for fast spots repair.
Substrates 1K Basecoat.
Mixing Ratio Clear Coat Hardener Thinner
2 1 0.1~0.3
<25℃ 680 Extra Fast Drying
Clear Coat 681 Extra Fast Dry
Hardener 62 Fast Thinner
Spray
Viscosity 14-16s to drop off, in 4# viscosity cup at 25°C,
Pot-Life At 25°C, 1.5 hour.
Re-Treatment There are particles or runs after spray, sand affected area with
P2000 sand paper
after thorough drying, then polish to solve the problem.
Spray Gun Set Up Gravity Feed: 1.2-1.5mm 4-5kg/cm ²
Suction Feed: 1.4-1.6mm 4-5kg/cm²
Spray
Technology Coats&Thickness: 2-3 coats, total 25-35um
Flash-Off Time: At 25°C, 5-10 minutes between two coats,
Air-Drying Time: Allow 10-15 minutes air drying time before force drying
Drying Time Temperature Dust Free  Tack Free Dry to Handle
Dry to Test
25°C  15 minutes  2 hours 4 hours  5 days
70°C 3 minutes 10 minutes  15 minutes  45 minutes
Shelf Life  2 years in original sealed can, cool and dry place at 20℃.
Package 5L×4 or 2.5L×8 or 5L+2.5L+1L
Note:
1. This products are extra fast reaction, after mixing clear coat with hardener,
just add small quantity of thinner for spraying, the mixture should be used up
within 1 hour.
2. The spray viscosity could not be too high, in case of paints defects, such as
orange skin.
3. This product is suitable for spots repairs, not suitable for overall repair.
4. At temperature lower than 8°C, a forced dry by baking is recommended.
5. It is recommended to apply at conditions of temperature lower than 25°C and
humidity lower than 80%, otherwise there will be defects such as
blistering or blushing.
6. The products mixed with hardener should be used up soon and can not be restore
for future use; clean equipments immediately with thinner after application,
otherwise it is very difficult to be cleaned after dry.

Minimum Order: 100 pieces

MF-680 Extra Fast Clear Coat.
Enlarge Click to Enlarge
SOURCE: Import-Export Bulletin Board (http://www.imexbb.com/)
Report Abuse

Involved in International Trade? Become an Advertiser!

Post an Offer to Sell

© 1996-2010 IMEXBB.com. All rights reserved.

IMEXBB.com