Home > Offers to Sell > Environment & Recycling > Waste Management > Oil Purifiers
Transformer Oil Filteration and Hot Oil Circulation Processing Equipment
The transformer oil filter plant is a self-contained unit to upgrade the quantity
of oil. The duty cycle begins from pumping the dirty oil from the equipment (or
container) to a heat chamber. After heating the oil to a predetermined
temperature, it is then filtered through edge type filter or filter press to
remove all suspended impurities. It is then sprayed into a vacuum chamber where
the dissolved gases and water are vapourised and separated.
The heaters of the filter plant shall be controlled such that the hot point
temperature of oil shall note exceed 90°C as excessive heating will cause
deterioration of oil. Improved designs of filter plants employ heating just to
reduce the viscosity and to allow it to spread in a thin film, and high vacuum to
remove the dissolved gas and moisture.
Edge type filter elements are made up of special paper discs under end pressure.
Oil passes through the infinitesimal interstices between the discs, leaving solid
impurities at the paper edges. Non hygroscopic graded filters can be used in place
of edge filters, but they are much costlier.
The vacuum pump shall be capable of producing a vacuum of 2 ton or less, for
reducing the water content to a value of 10 ppm.
For reducing acidity, absorption device using activated alumina should be
incorporated in the operating cycle.
Minimum Order: 1 sets
Click to Enlarge
SOURCE: Import-Export Bulletin Board (http://www.imexbb.com/)
Involved in International Trade? Become an Advertiser!
Post an Offer to Sell
© 1996-2010 IMEXBB.com. All rights reserved.