KL-233 LEVEL CONTROLLER

Name: KL-233 LEVEL CONTROLLER
Product description :
The electronic level controller with 2 sensors will automate aquarium water
top off. Since safety is our number one concern, we include two float switch
sensors with our electronic water level controller. The first float switch
sensor triggers the feed pump (sold separately) to maintain the desire water
level. The second float switch sensor ensures dependability and offers
overflow protection. Our water level controller can also be used to protect
pump from running dry. It can be utilized in three ways :
1.In this mode the power supply will turn on if the water level in the sump
is low AND there is enough water in the storage tank. The power supply will
turn off if the water level in the sump is high AND there is not enough water
in the storage tank.
(View Operation diagram, MODE A-1)
With this set up the power supply will turn on as soon as the water level in
the sump drops below the set level. The power supply will turn off if the
water level in the sump is high the set level.
(View Operation diagram, MODE A-2)
2. The power supply will turn on when the level falls below the minimal level
of float sensor1 and will turn off when water rises the set point of the flow
sensor1. The float sensor2 acts as a backup sensor in the event the float
sensor1 is stuck. The level controller will not allow the power supply to
turn on if the water level in the sump reaches the maximum level of float
sensor2.
(view Operation diagram, MODE B)
3. Immerse the sensor1 and sensor2 in the measured solution(sump).With this
set up the power supply will turn on when both sensors detected that the
water level is below the minimum level and stop only when the water rises the
maximum level of both sensor.
(View Operation diagram, MODE C)

Minimum Order: 10 bags

Click to Enlarge