Gasoline engine with automatic transmission training station

Product Introduction
Based on the electronically controlled engine and automatic transmission, the
engine can be started, accelerated, decelerated and other working conditions
can be operated, and the automatic transmission can be operated in gear
display, neutral start, forward gear and reverse gear operation and stall
experiment. It can truly display the composition structure and working process
of electronically controlled gasoline engine and automatic transmission.
It is suitable for the teaching needs of secondary and higher vocational and
technical colleges, general education colleges and training institutions for
the theory and maintenance of automobile engines and automatic transmissions.
Second, functional characteristics
1. Real and operable electronically controlled gasoline engine and automatic
transmission, fully demonstrating the composition structure and working process
of electronically controlled engine and automatic transmission.
2. The panel of the training bench adopts 4mm thick high-grade aluminum-plastic
panel with corrosion resistance, impact resistance, pollution resistance, fire
prevention and moisture resistance, and the surface is sprayed with primer
treatment by special process; The panel is printed with a color circuit diagram
that never fades; Students can visually compare the circuit diagram and the
actual object of electronically controlled gasoline engine and dual-clutch
automatic transmission, and understand and analyze the working principle of the
control system.
3. The panel of the training bench is equipped with automobile instruments,
fuel pressure gauges and vacuum pressure gauges, which can display the engine
speed, vehicle speed, automatic transmission gear, fuel injection pressure,
intake manifold pressure and other parameter changes in real time.
4. The panel of the training bench is equipped with a detection terminal, which
can directly detect the electrical signals of each sensor, actuator and engine
control unit pin, such as resistance, voltage, current, frequency signal, etc.
on the panel.
5. The training platform is equipped with a diagnostic base, which can be
connected to a special or general automotive decoder to perform ECU code query,
read fault code, clear fault code, read data flow, perform component testing,
parameter setting, waveform analysis and other self-diagnosis functions for the
engine and automatic transmission electronic control system.
6. The training station is equipped with throttle control device, which can
facilitate the acceleration and deceleration of the engine.
7. The training platform is equipped with a brake system (brake pedal, brake
master cylinder, brake sub-cylinder, brake disc), which can perform stall test
of automatic transmission on the output shaft and detect the power parameters
of the engine and automatic transmission.
8. The training station is equipped with installation protection devices such
as power main switch, water tank protective cover, output shaft protective
cover, etc.
9. The base in front of the equipment testing panel is equipped with a 20cm
steel table, which is convenient for placing data, testing instruments, etc.
10. The base of the training bench adopts steel structure welding, the surface
adopts spraying process treatment, with self-locking caster device, and
circular handguard bars are welded in front/both sides, which is flexible in
movement, safe and reliable, strong and durable.