hydrogen atmosphere tube furnace for chemical laboratories

Tube type hydrogen furnace can be used for pumping vacuum and passing atmosphere,
so it is also called vacuum tube furnace and atmosphere tube furnace. The tube is
made of a seamless nickel-based alloy that can be used for all inert gases and
oxygen to 30 PSI (pounds per square foot). 
In order to match the test requirements for the introduction of hydrogen, this tube
furnace is equipped with a manual ignition device at the right end of the furnace
tube, which can ensure the safety of the test; a vacuum gauge and a air pressure
gauge are arranged on the left side of the furnace tube to control the vacuum and
atmosphere inside the furnace tube. Further safety of the test is ensured by the
interlocking of the solenoid valve and the pressure sensor and the flammable gas
detection device.
This equipment also includes a two-way float flow meter with a stainless steel
needle valve and a air pressure gauge to accurately mix the gas that meets the test
requirements. Under normal circumstances, this set of instruments is used with a
double stage rotary vane vacuum pump to achieve a general low vacuum test
environment. If you need a higher vacuum, you can contact our technicians to select
a more powerful molecular pump.

Applications: 
It is widely used in materials or chemical laboratories to sinter various new
material samples in a hydrogen or hydrogen-nitrogen mixed gas state.

Technical parameter
supply voltage：AC220V, 50Hz
maximum power：2.5KW
heating zone：440mm
operating temperature：1100℃(1200℃<1h)
temperatur , e control accuracy：+-1℃
heating rate：Recommended≤10℃/min
temperature control：
AI-PID 30-stage process curve, can store multiple curves.
Independent control of three temperature zones with overheating and open circuit
protection
Furnace tube size：φ100mm O.D×1000mm L
Furnace tube material：High purity quartz

Minimum Order: 1 sets

Click to Enlarge