Self priming vortex water pump

Self-priming gas-liquid mixing vortex pump

The suction inlet of the gas-liquid mixture pump can use the negative pressure
action to inhale the gas, without the use of air compressor and atmospheric
ejector.

The high speed rotating impeller of the pump mixes the liquid and the gas, without
stirrer and mixer.

Due to the pressurized mixing in the pump, the gas and liquid are fully dissolved,
and the dissolution efficiency can reach 80-100%.

Highly soluble solutions can be produced without large pressurized dissolved gas
tanks or expensive reaction towers.

The gas-liquid ratio is about 1: 9 (inspiratory capacity is 8-10%), and the
inspiratory capacity can be increased by using in series

A gas-liquid mixing pump can inhale, mix, dissolve and directly deliver the highly
dissolved liquid to the point of use.

The use of gas-liquid mixing pump can improve the efficiency of dissolved gas-
liquid production, simplify the production device, save the site, save the
operation cost and maintenance cost

Application

The pump is mainly used for gas-liquid mixing and stirring, liquid transport,
circulation and pressurization, ozone water preparation, oxygen-rich water
preparation, as well as water, pure water, food spray treatment.

Thin, clean, low viscosity or liquid containing fine impurities Liquid temperature:
-15 to 120 degree Celsius

gas-liquid ratio is about 1: 9 (inspiratory capacity is 8-10%)

Self-priming height is about 9m (NPSH)

The suction inlet is horizontal and the exhaust outlet is vertical

Minimum Order: 1 sets

Click to Enlarge