1200A AC 2MHz Handheld Current Clamp GFUVE P50 50mm Hole Split Core Probe

The round jaw design on the P50 Series clamp on current probes along with the high
content nickel metal core makes them well suited for power quality applications
where high accuracy and low phase shift along with wide frequency are important.
Measurement range is 1mA to 1200A.
The P50 clamp current transformer is a general purpose 1000A AC current probe
designed for use with DMMs, loggers and other instruments that have a current
input. It has a 1000:1 ratio and output of 1mA per amp or 1mV per amp measured in
the jaw. The P50 clamp current probe has an integral 2.5m lead terminated. The
rounded jaw design on this probe makes it well-suited for power applications where
high accuracy 0.1% and low phase shift and wide frequency response are important.

Electrical parameters
Ratio: 1000: 1 or 2000:1 (customized)
Accuracy class: 0.1%, 0.2%, 0.5%
Primary current: 0 - 1000A AC
Secondary output: 1mV/A AC, 5mV/A or (customized)
Secondary current: 0 - 1000mA AC and 0 - 5A AC
Max. Cont. Input current: 1200A
Load capacity: ≤20Ω , Standard 4Ω
Over voltage category: CAT III 600V
Output signal: 333mV, 500mV,1V,2V,5V AC at nominal input current
Accuracy (1000A Range)
0-10A: ≤0.5%
10-100: ≤0.2%
10-1200A: ≤0.1%
Phase Shift(1000A Range)
0-10A: ≤0.5°
10-100: ≤0.2°
100-1200A: ≤0.1°
Frequency range: 40Hz-2000Hz or 10-2MHz
Dielectric strength: 3KV 50Hz/60Hz at 1 minute
Temperature range: -20°C to +55°C
Output: 2.5 meter cable with D01 connector
Max. voltage not insulated conductors: 600 V
Standard: EN 61010-1, EN 61010-2-032, EN 61010-2-031
IEC60044-1, & IEC61869-2, 600V CAT III
Installation: Clamp type
Output mode: Lead output (2.5m)
Connector: BNC, 4mm banana, signal cable(2 cores),customized

Mechanical parameters
Dimensions (L x W x H) (mm): 102.9 x 219.6 x 28
Weight (g): 550
Holding wire diameter (mm): φ50
Max. jaw opening (mm): 50
Jaw color: Gray or blue
Material: PC+ABS+Polycarbonate, UL94 V0

Minimum Order: 3 pieces

Click to Enlarge