AC/DC 200A 1mV/A 10mV/A Clamp on Current Probe D20 GFUVE Linearity 0.1%

The Model D20 AC/DC current clamp is a portable 100A/200Arms current probe with
insulated BNC output cable that can accurately measure AC or DC current waveforms.
The unit has proportional mV output for direct readings on oscilloscopes from DC
to 1MHz at -3dB. The D20 is power by a rechargeable multimeter battery or from a 9
V power signal cable. It is the perfect tool for most of the oscilloscopes.
The D20 current clamp is a general purpose 200A AC/DC current probe designed for
use with DMMs, oscilloscopes, power loggers and energy meter calibration
instruments that have a current input. It has a 1000:1 ratio and output of 10mV
per amp measured in the jaw. The D20 current probe has an integral 2.5m lead
terminated. The rounded jaw design on this current clamp makes it well-suited for
power applications where high linearity 0.1% and low phase shift and wide
frequency response up to 200kHz are important.

Electrical parameters
Ratio: 1000: 1 or 2000:1 (customized)
Accuracy class: 0.2%, 0.5%, 1%, 2%
Primary current: 0 - 100A or 0-200A AC/DC
Signal output: 10mV/A or 1mV/A
Secondary voltage: 0 - 1V or 0 - 2V AC/DC
Max. Cont. Input current: 200A AC/DC
Load capacity: ≤20Ω , Standard 4Ω
Over voltage category: CAT III 600V
Linearity: 0.1%
Frequency range: 10Hz-1MHz
Frequency response time: ≤10us
Phase Shift at 50/60Hz: ±1°
Dielectric strength: 3KV 50Hz/60Hz at 1minute
Temperature range: -40°C to +55°C
Output: 2.5 meter cable with D01 or BNC connector, 4mm banana
Max. voltage not insulated conductors: 720 V
Power supply: 5V or 9V DC
Standard: EN 61010-1, EN 61010-2-032, EN 61010-2-031
IEC60044-1, & IEC61869-2, 600V CAT III
Installation: clamp type
Output mode: lead output(2.5m)
Pollution Degree: 2
Protection: IP40
Connector: BNC, 4mm banana, signal cable(4 cores),customized

Mechanical parameters
Dimensions (L x W x H) (mm): 53 x 138 x 28
Weight (g): 420
Holding wire diameter (mm): φ20
Max. jaw opening (mm): 20
Jaw color: Red, black
Material: PC+ABS, UL94 V0

Minimum Order: 3 sets

Click to Enlarge